OmniTurn
 Fast... Precise... Affordable...
OmniTurn Legacy Software Downloads
The software on this page is for the older floppy-drive and hard-drive OmniTurns built prior to the G4 CNC (mid-2009). Support for LCD monitor (VGA) is included, selectable at installation.
USB floppy drive emulator is available to provide USB compatibility for these old-style CNC's

Create OmniTurn CNC System Disk
OmniTurn CNC Control Software GT-75 Lathe 1. OmniTurn Inverter Drive on GT-75
OmniTurn CNC Control Software Retrofit Lathe 2. OmniTurn Inverter Drive on Attachment
OmniTurn CNC Control Software C-Axis Yaskawa 3. OmniTurn C-Axis w/ "Y" in S/N
OmniTurn CNC Control Software C-Axis Baumuller 4. OmniTurn C-Axis w/ "B" in S/N
OmniTurn CNC Control Software C-Axis Indramat 5. OmniTurn C-Axis w/o "B" in S/N
OmniTurn CNC Control Software 2 Axis
6. Oldest Style CNC; Pre '95. Pre MC2

OmniTurn Hard Drive
OmniTurn CNC Control Software UPDATE Hard Drive 7. UPDATE Exec on Hard Drive
OmniTurn CNC Control Software for INDRAMAT 8. SETUP Indramat C-Axis
OmniTurn CNC Control Software (HDSU 3.3.6) 9. SETUP Inverter or Baumuller C-Axis
OmniTurn CNC Control Software YASKAWA C-Axis (OMNI4) 10. SETUP Yaskawa C-Axis
OmniTurn CNC Control Software pre-1995 2AX (OMNISLID) 11. SETUP Oldest (pre-1995) 2AX


OmniTurn
(541) 332-7004
(541) 332-1018 fax
email sales@omniturn.com